Speedlox Straight Flare to AN ORB Adapter

Speedlox locks and seals your 37 degree hose end to the fitting with only hand tightening. No more worry of inadvertent "back off" creating leaks at the connection. The Speedlox patented Dual locking system, locks both the hose end and the locking sleeve to the main fitting body. Thermal cycling combined with the inherent vibration of a machine during operation creates this costly condition. With the patent-pending PTFE sealing system, leaks or weeping at the hose end or fitting connection are a thing of the past.

The most unique feature of Speedlox is that you only have to hand tighten the connection to seal it, then push the locking sleeve forward to lock it. Speedlox will never cross-thread with the patented "B" nut guide.

U.S. Patent # 5882044 Patent Pending All Components Made and Assembled in U.S.A 1 Year Limited Manufacturer’s Warranty.

Installation

1. Thread in the Speedlox fitting
2. With one finger, move the lock ring tangs
together and slide the locking sleeve back into the unlocked position
3. Torque the Speedlox fitting to specifications of the AN counterpart
4. Install your existing hose end or B-Nut and tighten by hand
5. The mating surfaces of the hose end must come into contact with the PTFE seal, then compressed in order to seal the connection
6. Align internal and external splines
7. Push the locking sleeve forward until the internal lock-ring snaps into the locked position

Note:

• Speedlox in the unlocked position allows for adequate wrench clearance to tighten the fitting body
• The line connection may be inserted into the BNut guide, then unlocked and threaded on
• A wrenching surface is provided to enable the connection to be torqued to specs if required

Removal

1. With one finger hold the release tang to the other side of the opening and slide the locking sleeve to the unlocked position
2. Un-thread the connection

Winner of the 2010 SEMA ‘Best Performance Plumbing product’

Note:

• Do not attempt to unthread the connection without unlocking and disengaging the Speedlox locking sleeve first. Failure to do so may cause internal damage to the unit
• Threaded AN Caps should be used when Speedlox is not in use. Phenix recommends that if your hose end does not rotate freely, you should replace it with a new hose end
• Both threaded ends should be lubricated prior to installation The locking sleeve should be in the unlocked position when the body is threaded into the parent material

Installation Video